通用banner
current location : Home > news > Company news

Contact UsContact Us

Dalian Yamei Handicraft Co., Ltd

Landline:8670-8008

phone:139-4083-3288

Mailbox:xue@dl-yamei.com

website:   www.yamei-tiffany.com

Address:Ying Cheng Zi Zhen Nan Gou Cun, Ganjingzi District, Dalian City, Liaoning Province

Simple can making

2020-04-16 10:00:40

You can use microwave oven to make Bai dried flowers and leaves, of course. Put the flowers or leaves to be made into the burning cup, then pour in the absorbent beads (silica gel) and shake, so that the micro beads can be mixed into the flower Dao petals and leaf seams, and then put in the microwave oven, dry until dry, take out

There are many online tutorials about making bracelets, or go to the bookstore to buy a beaded book


This is a simple can handicraft

1、 Vertical shaft windmill

1. Divide the can vertically into eight equal parts, cut it into strips along the line with a sharp knife, and then cut a small hole at the upper and lower ends of the incision. The cross cut small openings should not be connected and should be staggered to avoid breaking when the blade is twisted.

2. Twist each of the eight strips into one direction at an angle. The size of the angle should be consistent, and then a snap fastener is inserted into the triangular opening at the top of the can to make a support bearing, and a 1.5mm small hole is drilled at the center of the bottom of the can.

3. Sharpen the upper end of the bicycle spoke, insert the lower end into a board to make a bracket, and put the finished windmill model on the bracket. At this time, as long as the breeze blows, the windmill can rotate rapidly.


2、 Anemometer model

Cut off the left half of the can with scissors on one side, and cut off the right half on the other side. Drill a 1.5mm hole horizontally in the middle of the can as shown in the figure, and insert a snap fastener into the upper hole to make a support bearing. At this time, the anemometer model is made, and it can rotate quickly and slowly with the wind speed.


3、 Air convection demonstration

Take the bottom half of the can, cut 16 leaves about 2cm deep along the incision, and flatten them into straw hat shape. Then twist each blade in one direction by one angle. Drill a 2-3mm small hole in the center of the bottom, and insert a snap fastener into the hole to make a support bearing. Put the Demonstrator on the stand and light the candle and it will keep turning.

Table lamp made of cupping.


标签

上一篇:没有了
下一篇:What is handicraft2020-12-28 10:06:49

Z近浏览:

相关产品

相关新闻

share:未标题-21.png未标题-23.png未标题-24.png

Copyright © Dalian Yamei Handicraft Co., Ltd